This weekend I wanted to share a technique/design that I learned from a stampin' Up website (Stamp and Scrap with Frenchie). The design is a sunburst or ray design, not a new design but very pretty. The trick is to cut all of your papers at the same time so that they fit back together well.
These are the steps I took:
- I selected the size car I wanted to make and the orientation (4 1/4 x 5 1/2, portrait)
- I decided that the "rays" would cover 3/4 of the card. this means that the innermost mat would be about 3 1/2 x 4 inches.
- I chose my patterned papers, and cut all of them to 3 1/2 x 4 inches.
- For the card below, I had 6 different designs. They were all paper so they were thin enough that I didn't have trouble cutting them.
- I laid the stack of papers on my cutting mat and found the bottom center of the paper stack. This is important because this is where I would place one end of my ruler. I used an xacto blade and a ruler to cut them.
- I started out on one end. After I cut each piece I placed it to the side so that I could keep them in order.
- Once I was done cutting, I took one piece from each cut stack and made my design.
- I ran a white card stock piece through my xyron to coat it with glue.
- To place my pieces on my white car stock, I started at a corner and built it out from there.
- I chose a coordinating piece of paper for the bottom portion of my card.
- Once I completed my design, I trimmed it (which is why it looks so perfect below). Since this was my first try, my papers ended up a little...shall we say...crooked? I used to take classes back in North Carolina. Whenever one of us messed up a card, we always said "sample card!"
The fun part of this card was the decorating! The focal point is usually where the design comes together at the bottom but on my third card (which you will see on Sunday) I didn't do that.
Close Up!
Here is my design, completed.
Here is another look at my finished card.
Come back again tomorrow for another example!
Lis
No comments:
Post a Comment